Internal Coating CBC-1, PowerKote? (3oz)

POWERKOTE� CBC-1 CERAMIC THERMAL BARRIER COATING

Combustion chamber coating for all metals.

• Excellent for piston tops.

Thermal barrier/heat management

• Reduces part temperature. Protective to above 2000�F.
• Keeps heat in the combustion chamber longer through the power stroke.
• Blurs hot spots. Reduces the potential for detonation.
• Highly resistant to thermal shock. Survives cyclic heating and cooling.

Increase torque and Horsepower

• Increase combustion chamber efficiency.
• Reduce fuel consumption.

Water-based, no hazardous fumes, non-flammable.

• Requires oven curing at 300�F for 1 hour.
• Easy cleanup with water.

Note: use CBX (below) if using nitrous oxide, supercharged, or turbocharged.

COMPLETE APPLICATION INSTRUCTION PDF: CLICK HERE

FOR: PISTONS COMBUSTION CHAMBERS VALVES

APPLICATION:

• All parts must be clean of all oils, dirt or other debris.
  

• Blast lightly with 10X EpiX Blasting Media MP 70/100 Grit (EPIX), 120 grit aluminum oxide, or similar material at low pressure.  Degrease with Columbia Coatings Super Degreaser (SD-MTO25) or similar non petroleum based solvent. Allow to full evaporate
  
  
• After STIRRING and shaking apply coating. Spray at an air pressure of about 60 psi through a fine nozzle.
  
  
• The coating has nearly the same appearance as the blasted part, so apply only enough to give a thin "wet" look to the part.
  
  
• Allow to dry to a "matte" finish. If humid use a fan or other tool to move air over the part to aid in drying.

• Bake at a minimum of 300f for 1 hour.
  
  
• Inspect part after cure for blisters, cracking or flaking. The coating should have a slight gold tint.
  
  
• DO NOT ASSEMBLE IF DAMAGE VISIBLE

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov